Tornado Taskforce 15 Trot-Mop

Questions and Answers

A
Andre BarreraAug 12, 2025
Why is my Tornado Vacuum Cleaner losing suction?
- J
  Jason TravisAug 12, 2025
  Loss of suction in your Tornado Vacuum Cleaner can occur for several reasons. The tank might be full, so you should empty it. The cloth filter assembly, hose, or wand could be clogged; in this case, clean the filter or remove the obstruction. A dented tank rim or worn seal can also cause this issue, so replace the tank or seal, respectively. If the float is not functioning properly, check to see if it moves freely or if the tank is full. For a loose or broken fan or a motor that isn't working, it's best to contact a service center.
R
Roy RodriguezAug 18, 2025
Why is my Tornado Vacuum Cleaner blowing dust?
- G
  Gabrielle OwensAug 18, 2025
  If your Tornado Vacuum Cleaner is blowing dust while running, the cloth filter is likely the culprit. Try cleaning it first. If the filter is torn, it will need to be replaced. Also, ensure the cloth filter is installed, especially when vacuuming very fine dust.
R
Rachel RiceAug 26, 2025
What to do if my Tornado Vacuum Cleaner motor is not running?
- M
  Melissa NormanAug 26, 2025
  If the motor of your Tornado Vacuum Cleaner isn't running, it could be due to a broken switch, a defective power cord, or a defective motor. It's best to contact a service center to resolve these issues.
K
Karen CharlesSep 2, 2025
What to do if my Tornado Vacuum Cleaner is blowing water?
- K
  Kathy SmithSep 3, 2025
  If your Tornado Vacuum Cleaner is blowing water while running, it's likely because the tank is full of liquid. Empty the tank. If you are picking up sudsy or foamy liquid, try adding a defoamer to the tank.