10
SET-UP INSTRUCTIONS
IMPORTANT: If battery is ever removed, make sure
battery clamp bolts are reinstalled with bolt heads
positioned on bottom side and nuts on top side. If
clamp bolts are reversed, they may interfere with hard
lines when shifting cutting units.
5. Coat both battery connections with Grafo 112X
(skin over) grease, Toro Part No. 505-47, petroleum
jelly or light grease to prevent corrosion and slide
rubber boot over positive terminal.
6. Install battery cover.
INSTALL SEAT (Fig. 4 - 7)
The Reelmaster 3100 is shipped without the seat
assembly. Deluxe Seat Kit, Model 03225 or Standard
Seat Kit, Model 03224, must be installed as follows:
1. Remove capscrews securing seat mounting
straps to traction unit frame (Fig. 4).
Figure 4
1. Seat mounting strap (2)
1
2. Secure seat mounting straps to seat adjusters with
(4) flange nuts (standard seat) or (4) capscrews, flat
washers and flange nuts (deluxe seat). Mounting
fasteners supplied with seat kit loose parts.
Figure 5
1. Standard seat 2. Seat adjusters 3. Seat belt
1
2
3
3. Install seat belt to holes on each side of seat with
(2) bolts and lockwashers (standard seat) or (2) bolts
and locknuts (deluxe seat). All mounting fasteners
supplied with seat kit loose parts.
4. Position seat and seat straps on frame aligning
mounting holes.
5. Route seat switch wire under right hand seat strap
and connect to appropriate seat switch connector on
harness.
6. On deluxe seat only, route unused seat switch
connector back under seat strap and secure both
wires to rear most hole in seat strap (Fig. 6) with a cable
tie (cable tie supplied with seat kit).
Figure 6
1. Seat switch wire
2. Cable tie
1
2
7. On standard seat only, slide seat all the way
forward, pull wire to the right so unused connector is
positioned as shown in figure 7 and secure seat switch
wire to rear most hole in seat strap with a cable tie
(cable tie supplied with seat kit).
Figure 7
1. Seat switch wire
2. Cable tie
1
2
8. Mount seat straps to frame with fasteners
previously removed.
9. Slide seat completely forward and backward to
ensure proper operation and that seat switch wires and
connectors are not pinched or do no contact any
moving parts.
To Next Page
Loading...
