Toro 03200 - Page 15

15
SET-UP INSTRUCTIONS
ADJUST LIFT ARMS (Fig. 24 - 28)
1. Start engine, raise lift arms and check to make sure
clearance between each lift arm and floor plate bracket
is .18" - .32" (Fig. 24). If clearance is not in this range,
back off stop bolts (Fig. 26) and adjust cylinder to attain
clearance. To adjust cylinder, back off the jam nut on
the cylinder (Fig. 25), remove pin from rod end and
rotate clevis. Install pin and check clearance. Repeat
procedure if required. Tighten clevis jam nut.
Figure 24
1. Lift arm 2. Floor plate bracket 3. Clearance
1
2
3
2. Check to make sure clearance between each lift
arm and stop bolt is .005" - .040" (Fig. 26). If clearance
is not in this range, adjust stop bolts to attain
clearance.
3. Start engine, raise lift arms and check to make sure
clearance between wear strap on top of rear cutting
unit wear bar and bumper strap is .020" - .100"
(Fig. 27). If clearance is not in this range, adjust rear
cylinder to attain clearance. To adjust cylinder, lower
the cutting units and back off the jam nut on the
cylinder (Fig. 28). Grasp cylinder rod close to the nut
with a pliers and rag and rotate the rod. Raise the
cutting units and check clearance. Repeat procedure if
required. Tighten clevis jam nut.
Figure 25
1. Front cylinder
2. Jam nut
1
2
Figure 26
1. Stop bolt
2. Lift arm
3. Clearance
1
2
3
Note: If rear lift arm clunks" during transport,
clearance can be reduced.
Figure 27
1. Wear bar
2. Bumper strap
1
2
Figure 28
1. Rear cylinder
2. Adjusting nut
1
2
IMPORTANT: Lack of clearance at front stops or
rear wear bar could damage lift arms.