20
CONTROLS
Engine Coolant Temperature Warning Light
(Fig. 37) Light glows if engine coolant temperature
is high. If traction unit is not stopped and coolant
temperature rises another 10 F., the engine will kill.
Oil Pressure Warning Light (Fig. 37) Light glows if
engine oil pressure drops below a safe level.
Alternator Light (Fig. 37) The amp light should be
off when engine is running. If it is on, the charging
system should be checked and repaired as necessary.
Glow Plug Indicator (Fig. 37) Indicator light will
glow when glow plugs are operating.
Parking Brake (Fig. 37) Whenever the engine is
shut off, the parking brake must be engaged to prevent
accidental movement of the machine. To engage the
parking brake, pull up on lever. Engine will stop if
traction pedal is depressed with parking brake
engaged.
Lift Lever Lock (Fig. 37) Move lever rearward to
prevent cutting units from dropping.
Reel Speed Control - (Fig. 38) (Located under
console cover) - To obtain the desired clip rate (reel
speed), rotate reel speed control knob to appropriate
setting for height-of-cut setting and mower speed.
Refer to Selecting Clip Rate section of Manual.
Backlap Control - (Fig. 38) (Located under
console cover) - Rotate knob clockwise for
backlapping and counterclockwise for mowing. Do
not change knob position when reels are rotating.
Figure 38
1. Reel speed control
2. Backlap control
2
1
Fuel Gauge (Fig. 39) Registers amount of fuel in
tank.
Seat Adjustments (Fig. 39)
Fore and Aft Adjustment Move lever on side of seat
outward, slide seat to desired position and release
lever to lock seat into position.
Deluxe Seat Adjustments
Weight Adjustment Push lever up or down to adjust
to operator's weight. Lever up light operator, lever in
middle position medium weight operator or lever
down for heavy operator.
Inclining Backrest Turn handle to adjust angle of
backrest.
Figure 39
1. Fore and aft lever
2. Fuel gauge
2
1
To Next Page
Loading...
