Toro 07411EX - Page 34

g192345
Figure37
1.Cotterpin
3.Dustcap
2.Nutretainer
9.Installthecotterpinandbendeachlegsaround
theretainer(Figure37).
10.Installthedustcapontothehub(Figure37).
11.Repeatsteps1through10forthehubandrotor
attheothersideofthemachine.
InstallingtheBrakesandWheels
1.Cleanthe2ange-headbolts(3/8x3/4inch)
andapplyacoatofanti-seizecompoundtothe
threadsofthebolts.
2.Alignthebrakepadstoeithersideoftherotor
(Figure32)andtheholesinthecaliperbracket
withtheholesinthebrakemountofthespindle
frame(Figure36).
3.Assemblethecaliperbrackettothespindle
frame(Figure32)withthe2ange-headbolts
(3/8x3/4inch),andtorquetheboltsto47to54
N∙m(35to40ft-lb).
4.Aligntheholesinthewheeltothestudsofthe
hubandassemblethewheeltothehubwiththe
valvestemoutward(Figure31).
Note:Ensurethatthemountingsurfaceofthe
wheelisushwiththehub.
5.Securethewheeltothehubwiththelugnuts
(Figure31),andtorquethenutsto108to122
N∙m(80to90ft-lb).
6.Repeatsteps1through5forthebrakeand
wheelattheothersideofthemachine.
34
All manuals and user guides at all-guides.com