Installing the LED Light Kit
Note: For installation assistance, contact an
Authorized Service Dealer .
1. Install the light bracket onto the front of the
machine using the 2 hex-washer-head thread
forming screws (5/16 x 3/4 inch).
g468945
Figure 1
2. Install the light to the light bracket using the 2
hex-washer-head screws.
g468946
Figure 2
3. Connect the wire harness to the back of the
lights and secure the harness to the front frame
rail using the harness clip.
g468947
Figure 3
1. Harness clip
4. Route the wire harness along the right frame
rail, while securing the harness clips to the rail.
g468948
Figure 4
5. Cut the cable tie securing the auxiliary connector
of f the main harness and remove the auxiliary
end plug.
6. Connect the light harness to the auxiliary
connector .
7. Secure the kit wire harness to the machine wire
harness using the cable tie.
8. Electric machines only: install the batteries.
2
To Next Page
Loading...