Toro 20332 - Adjusting Cutting Height and Starting Engine; Adjusting the Cutting Height; Starting the Engine

AdjustingtheCuttingHeight
WARNING
Adjustingthecuttingheightmaybringyouinto
contactwiththemovingblade,causingserious
injury.
•Stoptheengineandwaitforallmovingparts
tostop.
•Donotputyourngersunderthehousingwhen
adjustingthecuttingheight.
CAUTION
Iftheenginehasbeenrunning,themuferwillbe
hotandcanseverelyburnyou.Keepawayfromthe
hotmufer.
Adjustthecuttingheightasdesired.Setthefrontwheelsto
thesameheightastherearwheels(Figure11).
Note:Toraisethemachine,movethefrontcutting-height
leversrearwardandtherearcutting-heightleversforward.
Tolowerthemachine,movethefrontcutting-heightlevers
forwardandtherearcutting-heightleversrearward.
Figure11
1.Raisethemachine2.Lowerthemachine
Note:Thecutting-heightsettingsare25mm(1inch);35
mm(1-3/8inches);44mm(1-3/4inches);54mm(2-1/8
inches);64mm(2-1/2inches);73mm(2-7/8inches);83mm
(3-1/4inches);92mm(3-5/8inches);and102mm(4inches).
StartingtheEngine
1.Holdtheblade-controlbaragainstthehandle(Figure
12).
Figure12
1.Blade-controlbar
2.Pushtheelectric-startbutton(electric-startmodel
only;refertoFigure13)orpulltherecoil-starthandle
(Figure14).
Note:Iftheelectric-startbuttonhasbeenremoved,
insertitintotheelectricstarter;refertoFigure13
(electric-startmodelonly).
G020174
1
2
3
Figure13
Electricstart
1.Electricstarter3.Electric-startbutton
(installed)
2.Electric-startbutton
Note:Whenyoupulltherecoil-starthandle,pullit
lightlyuntilyoufeelresistance,thenpullitsharply
(Figure14).Allowtheropetoreturntothehandle
slowly.
9