14
BEFORE OPERATING
REAR DECK CHAIN
1. Remove hair pin cotter and clevis pin securing
height-of-cut chain to chamber bracket.
2. Mount height-of-cut chain to desired
height-of-cut hole with clevis pin and hair pin cotter.
Figure 22
1. H.O.C. Chain
1
Figure 23
CHECK TIRE PRESSURE
Ensure that the air pressure in the front and rear castor
wheels is 40 psi (276 kPa).
IMPORTANT: Maintain even pressure in all tires to
ensure a good qualityofcut and proper machine
performance. Do not underinflate.
ADJUST SKID
Skid, on right side of cutting unit, should be located in
upper holes for 1 and 1-1/2 inch heights-of-cut and
lower holes for 2 to 4 inch heights-of-cut.
1. Adjust skid by removing flange nuts, positioning as
desired and re-installing flange nuts.
ADJUST ROLLER
Anti-scalp rollers should be located in upper holes for
1 and 1-1/2 inch heights-of-cut and lower holes for
2 to 5 inch heights-of-cut. Five rollers are located on
the deck, three under the main deck and one on each
wing.
1. Adjust anti-scalp rollers by removing screw
securing roller shaft to deck, positioning roller as
desired and reinstalling shaft with screw.
To Next Page
Loading...
