Toro 38518 - Product Setup Instructions; Installing the Handle Assembly

Setup
Loose Parts
Use the chart below to verify that all parts have been shipped.
Step
Description
Qty.
Use
Handle bolt
1
Curved washer
1
1.
Knob
1
Install the handle.
Discharge chute
1
Phillips head screws
3
Washers
3
2.
Locknuts
3
Install the discharge chute.
Chute crank and mounting plate
1
Bolts
2
3.
Locknuts
2
Install the chute crank.
1. Installing the Handle
1. Cut the plastic tie that secures the control cable to the
handle .
Note: Hold the cable taut to ensure that it sta ys
connected at the bottom.
2. P osition the upper handle as sho wn ( Figure 3 ).
Figure 3
3. Loosely install the handle bolts , cur v ed w ashers , and
knobs ( Figure 4 ).
Figure 4
4. Hook the end of the control cable spring into the
bottom hole of the control bar ( Figure 5 ).
Figure 5
5. Fully inser t the handle bolts ( Figure 6 ).
Important: Ensur e that y ou do not pinch the
contr ol ca ble ( Figur e 6 ).
6