Toro 38584 - Setup Procedures; Loose Parts Verification; Handle Assembly

Setup
LooseParts
Usethechartbelowtoverifythatallpartshavebeenshipped.
ProcedureDescription
Qty.
Use
1.
Nopartsrequired
–
Unfoldthehandle.
Screws
3
2.
Chuteassembly
1
Installthedischargechute.
1.UnfoldingtheHandle
Procedure
1.Loosenthelowerhandleknobs,pulloutthehandle
boltsuntilyoucanmovethehandlefreely,androtate
thehandletotheoperatingposition(Figure3).
Figure3
1.“U”-shapedhandlelock(2)
2.Handleknobs
2.Inserttheendofthe“U”-shapedhandlelockinto
theopenholeinthehandleandtightenthehandle
knobsuntiltheyaresnug(Figure4).
Figure4
Important:Ensurethatyoudonotpinchor
kinkthecontrolcableortheQuickShoot™
cables(Figure5).
Figure5
1.Controlcable2.QuickShoot™cables
5