Operation
28
Instruments
Hour Meter
The hour meter records the number of hours the
engine has operated. It operates when the engine is
running. Use these times for scheduling regular
maintenance.
1
m–3077
Figure 9
1. Hour
meter
Fuel
T
anks
The unit has two fuel tanks, one located on the left
side and on the right side. Each tank connects to the
fuel shut off valve in the control panel. From there a
common fuel line leads to the engine (Fig. 10).
To use the right side fuel tank rotate the fuel shut off
valve 1/4 turn to the right from the off location. This
uses fuel from the right side tank only. When the right
hand fuel tank is empty, move the fuel shut off valve
1/4 turn to the left from the off position.
Close fuel shut off valve, on front panel before
transporting or storing machine.
Figure 10
1. Shut
of
f valve
Adjusting
Height-of-Cut
The height-of-cut is adjusted from 1-1/2” to 5”
(38 to 127 mm) in 1/4” (6 mm) increments by
relocating clevis pin in different hole locations.
1. Raise the height-of-cut lever to the transport
position (also the 5” (127 mm) cutting height
position) (Fig. 11).
2. To adjust, remove hairpin cotter and clevis pin
from height-of-cut bracket (Fig. 11).
3. Select hole in height-of-cut bracket
corresponding to the height-of-cut desired. Lift
handle to transport position, insert clevis pin
(Fig. 11).
4. Secure clevis pin with hairpin cotter (Fig. 11).
5. Move lever to selected height.
1
3
2
Figure 1
1
1. Height
of cut lever
2.
Clevis Pin
3.
Hairpin Cotter
To Next Page
Loading...
