Toro 74236 - Maintenance; Recommended Maintenance Schedule

27
Maintenance
Note: Determine the left and right sides of the machine from the normal operating position.
Recommended Maintenance Schedule
Maintenance Service
Interval
Maintenance Procedure
After first use
• Check hydraulic fluid level
• Change engine oil
• Change hydraulic filter
Each Use
• Check engine oil level
• Check safety system
• Clean engine cooling system
1
• Clean mower housing
• Check engine coolant
Every 5 Hours
• Check cutting blades
• Grease blade spindle bearings
Every 25 Hours
• Check hydraulic fluid level
• Grease chassis
1
• Oil linkage bushings
1
• Check battery electrolyte
Every 50 Hours
• Service air cleaner
1
• Check belts for wear/cracks
• Check tire pressure
• Service the spark arrester
Every 100 Hours
• Replace paper air cleaner
1
• Change spark plug(s)
• Check hydraulic lines
• Change engine oil
1
• Check fuel system
• Check cooling system hoses
Every 200 Hours
• Change oil filter
1
• Replace fuel filter
• Check engine cooling system
• Replace hydraulic filter
Every 400 Hours • Change engine coolant
Every 500 Hours or at
Storage
• Adjust castor pivot
• Adjust wheel hub slotted nut
Before Storage Service
• Charge battery, disconnect cables
• Drain gasoline
• Paint chipped surfaces
• Perform all maintenance procedures listed above before storage
1
More often in dusty, dirty conditions
Important Refer to your engine operator’s manual for additional maintenance procedures.