What to do if my Toro Riding mower starter does not crank?
If the starter on your Toro Riding mower isn't cranking, make sure that the blade control (PTO) is disengaged, the parking brake is set, and you are sitting on the seat. Also, check if the battery is dead and needs charging, ensure electrical connections are making good contact, and replace the fuse if it's blown. If none of these steps work, the relay or switch may be defective.
Why is my Toro Riding mower engine losing power?
If your Toro Riding mower engine is losing power, try reducing your ground speed. Check the air cleaner and clean it if it's dirty. Ensure the oil level in the crankcase is sufficient, and clear any obstructions from the cooling fins and air passages under the engine blower housing. Replace pitted, fouled, or incorrectly gapped spark plugs, and replace the fuel filter if it's dirty. If problems persist, there may be dirt, water, or stale fuel in the fuel system.
General| Brand | Toro |
|---|---|
| Model | 74251 |
| Category | Lawn Mower |
| Language | English |
Instructions for operating the equipment safely and avoiding injury.
Identification and function of various control levers, switches, and gauges on the machine.
Procedures and safety precautions for refueling the machine with gasoline.
How to check the engine oil level before operation.
Instructions on how to properly use the ROPS for safety.
How to set and release the parking brake for safe operation and stopping.
Step-by-step guide on how to safely start the engine.
Procedures for safely shutting down the engine after operation.
How to engage and disengage the PTO for operating mower blades and attachments.
Explanation of how safety interlocks prevent starting or stop the engine under certain conditions.
How to test the safety interlock system before each use.
Instructions for moving the machine forward safely.
Instructions for moving the machine backward safely.
Importance of maintaining sharp blades for clean cuts and preventing disease.
A table outlining maintenance tasks and their recommended service intervals.
General procedures for greasing and lubricating the machine's various points.
Procedures for removing, cleaning, and installing the air cleaner filter.
Instructions for changing the engine oil, including type and capacity.
How to check the engine oil level correctly.
How to check, remove, and install spark plugs for engine maintenance.
How to check the hydraulic fluid level and type.
Procedure for replacing the hydraulic filter and changing the hydraulic fluid.
How to level the mower deck for optimal cutting performance.
How to inspect blades for sharpness, wear, and damage.
To Next Page
