What to do if the blades do not rotate on my Toro Lawn Mower?
If the blades on your Toro Lawn Mower aren't rotating, verify the drive belt isn't worn, loose, or broken; if it is, install a new one. Also, check if the drive belt is off the pulley, and if so, install the drive belt and check the adjusting shafts and belt guides for the correct position. Finally, check if the mower belt is worn, loose, or broken and install a new mower belt.
Why is there an abnormal vibration in my Toro 74667?
An abnormal vibration in your Toro Lawn Mower can stem from several issues. Start by tightening any loose engine-mounting bolts. Next, check the engine pulley, idler pulley, or blade pulley and tighten them if loose. Replace the cutting blade(s) if they are bent or unbalanced. Also, ensure that the blade-mounting bolt is tightened.
How to adjust a Toro Lawn Mower for an even cut?
If your Toro Lawn Mower is leaving an uneven cut, several issues could be the cause. Start by sharpening the blade(s). If a cutting blade(s) is/are bent, replace it. Make sure the mower is level from side-to-side and front-to-rear. If equipped, check the anti-scalp roller setting and adjust the anti-scalp wheel height. Clean the underside of the mower deck. Finally, ensure the tire pressure is correct.
Why does my Toro 74667 Lawn Mower not drive?
If your Toro Lawn Mower won't drive, start by checking if the bypass valves are open and close the tow valves. For issues such as worn, loose, or broken traction belts, traction belts off the pulleys, or a failed transmission, contact an Authorized Service Dealer.
What to do if fuel tank collapses on my Toro 74667 Lawn Mower?
If the fuel tank of your Toro Lawn Mower is collapsing or the machine frequently runs out of fuel, the air-cleaner paper element may be clogged. Clean the paper element.
What causes abnormal vibration in my Toro 74667 Lawn Mower?
An abnormal vibration in your Toro Lawn Mower can stem from several issues: Check and tighten the engine-mounting bolts if they are loose. Tighten the engine pulley, idler pulley, or blade pulley if any are loose. Install a new cutting blade(s) if the current one is bent or unbalanced. Tighten the blade-mounting bolt if it's loose.
What to do if my Toro 74667 engine does not start, starts hard, or fails to keep running?
If your Toro Lawn Mower engine is having trouble starting or staying running, consider these possibilities: Ensure the fuel tank is full. Make sure the choke is on. Check and clean or replace the air filter if it's dirty. Verify the spark plug wire(s) are properly connected. Install a new, correctly gapped spark plug(s) if the old one is faulty. Replace the fuel filter if it's dirty. Add oil to the crankcase if the oil level is low. Drain the tank and replace the fuel with the proper type if there is incorrect fuel in the fuel tank.
Why does my Toro 74667 engine not start?
Several factors could prevent your Toro Lawn Mower engine from starting. The fuel tank might be empty, so fill it. If your model has a choke, ensure it's in the ON position. A dirty air cleaner can also be the culprit; try cleaning or replacing it. Check that the spark plug wire(s) is properly connected, and the spark plug isn't damaged. Also, make sure the fuel filter isn't clogged. Low oil level in the crankcase may also be the reason, add oil to the crankcase. Finally, ensure you're using the correct type of fuel.
Why won't my Toro 74667 Lawn Mower start?
If your Toro Lawn Mower engine does not start, starts hard, or fails to keep running, consider the following: * Ensure the fuel tank is filled. * Make sure the choke is on. * Check if the air cleaner is dirty; clean or replace it if necessary. * Verify the spark-plug wire(s) is securely connected to the spark plug. * Inspect the spark plug(s) for damage or incorrect gap; replace if needed. * Check for a dirty fuel filter and replace it if necessary. * If there is dirt, water, or stale fuel in the fuel system, contact an Authorized Service Dealer. * Ensure the correct fuel type is in the fuel tank; drain and replace if incorrect. * Check the oil level in the crankcase and add oil if low.
Why is my Toro Lawn Mower cutting height uneven?
If your Toro Lawn Mower is leaving an uneven cut, several factors could be responsible. Check if the blade(s) is sharp and sharpen if necessary. If a cutting blade(s) is bent, replace it. Ensure the mower is level from side-to-side and front-to-rear. Adjust the anti-scalp wheel height if it is not set correctly. Clean the underside of the mower if it's dirty, and adjust the tire pressure if it's incorrect.
General| Deck Material | Steel |
|---|---|
| Drive Type | Self-Propelled |
| Starting System | Recoil |
| Mulching Capability | Yes |
| Side Discharge Capability | Yes |
| Cutting Height Positions | 7 |
| Fuel Tank Capacity | 0.95 L |
| Bagging Capability | Yes |
| Cutting Width | 22" (56 cm) |
To Next Page
