CHASSIS
3-90 Toro GrandStand Service Manual
3
82. Using a hoist, support the weight of the engine and
engine base (Fig. 0338).
Fig. 0338 DSCN-1102a
84. Remove the two sets of carriage bolts and nuts
securing the rear of the engine base to the rear of
the mower deck (Fig. 0340).
Fig. 0340 DSCN-1112a
85. Repeat step 84 on the other side of the engine base.
86. Raise the engine and engine base off the mower
deck.
87. Remove one spark plug and feed a minimum of 2
feet (61cm) of 3/8” (.95cm) rope into the cylinder to
prevent engine rotation (Fig. 0341).
Note: Rotate crankshaft as needed to permit feeding
the rope into the cylinder.
Fig. 0341 IMG-9634a
83. Remove the bolt and nut securing the front engine
base mounting tab to the top of the mower deck (Fig.
0339).
Fig. 0339 DSCN-1107a
To Next Page
Loading...
