CHASSIS
3-132 Toro GrandStand Service Manual
3
34. Remove the bolt and washer securing the ground
wires to the engine block (Fig. 0498).
Fig. 0498 DSCN-0991a
36. Remove both sets of bolts, nuts and spacers secur-
ing the lower end of the control cables to the control
fork assemblies (Fig. 0500).
Fig. 0500 DSCN-0996a
37. Remove the spring clip securing the motion control
cables to the linkage mount (Fig. 0501).
Fig. 0501 DSCN-0999a
35. Disconnect the clutch wires from the wiring harness
(Fig. 0499).
Fig. 0499 DSCN-0993a
To Next Page
Loading...
