CHASSIS
3-140 Toro GrandStand Service Manual
3
Carrier Frame Installation
65. Remove the two front caster wheel assemblies. See
“Caster Wheel Assembly Removal” on page 3-17.
66. Using a drill, carefully remove the two pop rivets
securing the model/serial plate (Fig. 0530).
1. Using pop rivets, secure the original model/serial
plate to the carrier frame (Fig. 0531).
Fig. 0530 DSCN-1306a
Fig. 0531 DSCN-1306a
2. Install the two front caster wheel assemblies. See
“Caster Wheel Assembly Installation” on page 3-20.
3. Install the grease zerk into the LH & RH front pivot
hubs (Fig. 0532).
Fig. 0532 DSCN-1300a
To Next Page
Loading...
