CHASSIS
3-142 Toro GrandStand Service Manual
3
6. Secure the lift assembly to the carrier frame using
the large washer and “E” clip (Fig. 0536).
Fig. 0536 DSCN-1287a
9. Position the hydraulic reservoir in the hydraulic
reservoir mount (Fig. 0538).
Fig. 0538 DSCN-1276a
Note: Install the low pressure suction line to the
hydraulic lter inlet tting as the tank is being
lowered into position (Fig. 0539).
Fig. 0539 DSCN-1281a
7. Repeat steps 5 and 6 on the other side.
8. Secure the hydraulic lter head assembly to the
hydraulic reservoir mount using two bolts and
washers (Fig. 0537).
Fig. 0537 DSCN-1313a
To Next Page
Loading...
