Toro GrandStand Series - Page 187

CHASSIS
3-166 Toro GrandStand Service Manual
3
93. Secure the red positive cable to the positive terminal
on the battery using a bolt, washer, and nut (Fig.
0626).
Fig. 0626 DSCN-1495a
Note: Position the red protective boot over the
terminal once the cable is secured (Fig. 0627).
Fig. 0627 DSCN-1497a
94. Secure the black ground cable to the negative
terminal on the battery using the bolt, washer and
nut (Fig. 0628).
96. Verify the mower deck is properly adjusted. See
“Mower Deck Adjustments - Correcting the Mower
Quality of Cut” on page 7-50.
97. Bleed the hydraulic system. See “Bleeding the
Hydraulic System” on page 6-95.
Fig. 0628 DSCN-1499a
95. Secure the battery to the battery tray using the
battery cover, hold down bolts and wing nuts (Fig.
0629).
Fig. 0629 DSCN-1504a