Toro GrandStand Series - Controls; LH Motion Control Lever Replacement

CONTROLS
4-1Toro GrandStand Service Manual
4
LH Motion Control Lever
Replacement
LH Motion Control Lever Removal
2. Remove the two screws securing the pivot shaft in-
side the LH motion control lever (Fig. 0631 & 0632).
1. Remove the bolt, nut & spacer securing the end of
the control cable to the LH motion control lever (Fig.
0630).
Fig. 0630 IMG-0953a
Fig. 0631 IMG-0955a
Fig. 0632 IMG-0956a
Note: Only one bolt will typically back out due to
both threading into the same inner rod. A #4
easy-out can be used to secure the pivot rod.
The bolt on the opposite side can then be
removed (Fig. 0633).
Fig. 0633 IMG-0958a