Toro GrandStand Series - Page 190

CONTROLS
4-3Toro GrandStand Service Manual
4
LH Motion Control Lever Installation
1. Install a plastic bearing into each end of the control
handle (Fig. 0637).
3. Secure the control handle assembly in the control
tower using two bolts (Fig. 0639 & 0640).
Fig. 0637 IMG-0973a
2. Install the pivot rod into the center of the control
handle (Fig. 0638).
Fig. 0638 IMG-0971a
Fig. 0639 IMG-0955a
Fig. 0640 IMG-0956a