Toro GrandStand Series - Page 203

CONTROLS
4-16 Toro GrandStand Service Manual
4
5. Loosely install the large washer and nut securing
the control fork and shoulder hub assembly to the
linkage mount (Fig. 0688).
Note: This will be tightened later in this procedure.
6. 2009 Only: Serial range 290000001 – 290000209:
Slide 3 rollers onto the rear end of the RH shifter link
rod. Slide the rear end of the shifter link rod (with 3
rollers) into the control fork assembly (Fig. 0690).
Fig. 0688 IMG-1013a
Shifter Link and Roller Congurations (Fig. 0689):
A. 2009: Serial range 290000001-290000210;
3 rollers, all thin and same size
B. 2009: Serial range 290000211-290999999;
3 rollers, large center roller
C. 2010: Serial range 310000001-310999999;
3 rollers, all large and same size
Fig. 0689 IMG-0941a
Fig. 0690 IMG-9486a
7. 2009 Only: Serial range 290000210 -290999999:
Push down on the control fork assembly and slide
the center roller into the slot of the pump control arm
(Fig. 0691).
Fig. 0691 IMG-9436a
A
B
C