Toro GrandStand Series - Page 204

CONTROLS
4-17Toro GrandStand Service Manual
4
11. 2009 Only: Secure the front end of the RH shifter
link to the shifter bracket using a hairpin cotter and
washer (Fig. 0695).
8. 2009 Only: Serial range 290000210 -290999999:
Using an Allen wrench, locate the center roller and
slide the Allen wrench through it (Fig. 0692).
10. 2009 Only: Serial range 290000210 and up: Slide
the left hand roller onto the rear end of the right hand
shifter link rod and into the outside of the control fork
assembly (Fig. 0694).
Fig. 0692 IMG-9492a
9. 2009 Only: Serial range 290000210 -290999999:
Slide the right hand roller onto the rear end of the
right hand shifter link rod. Slide the rear end of the
shifter link rod (with roller) through the control fork
assembly following the Allen wrench through to
capture the center roller on the shifter link rod (Fig.
0693).
Fig. 0693 IMG-9432a
Fig. 0694 IMG-9430a
Fig. 0695 IMG-9422a