Toro GrandStand Series - Page 21

SPECIFICATIONS
2-10 Toro GrandStand Service Manual
2
International GrandStand Specications cont.
Mower Drive:
Mower Engagement: Engine Mounted Electric Clutch
Clutch Adjustment: Periodic Air Gap Adjustment Required - 0.45 ± 0.0762 mm (.018” ± .003”)
PTO Drive Belt: HB Section W/ Aramid (Kevlar) Cords and Dry Clutching Envelope
PTO Idler: Spring Loaded Pivot Hub w/Friction Washer Dampening
Deck Drive Belt: HA Section with Aramid (Kevlar) Cords and Standard (Non-Clutching)
Envelope
Deck Drive Idler: Spring Loaded Pivot Hub w/Friction Washer Dampening
Mower Decks:
HOC Range: 25.4mm (1”) to 127mm (5”) in 6.3mm (1/4”) increments
Blades: Three 6.3mm (.250”) Thick Heat Treated Steel Blades
Spindles: Machined Steel 25.4mm (1”) Diameter Shaft
Spindle Housing: Ductile Cast Iron, Mounted with Six Bolts
Bearings: Greasable Ball Bearings with Grease Fitting for Lubrication
Construction: 7 gauge (.179” / 4.5mm) Steel Welded Construction
Blade Tip Speed: 122cm (48”) - 18,750 ft/m calculated @ 3600 engine RPM
132cm (52”) - 18,750 ft/m calculated @ 3600 engine RPM
Skid Plate: Standard
Adjustable Discharge Bafe: Standard
Rubber Discharge Chute: Standard
Unit Dimensions:
Deck Width Height
Width
Deector
Down
Width
Deector
Raised
Length
Platform Up
Length
Platform
Down
Weight*
122cm (48”) 122cm (48”) 161cm (63.5”) 126cm (49.5”) 135cm (53”) 188cm (74”) 400 kg (881 lbs)
132cm (52”) 122cm (48”) 171cm (67.5”) 135cm (53”) 135cm (53”) 188cm (74”) 408 kg (900 lbs)
* Estimated operating weight