Toro GrandStand Series - Page 222

CONTROLS
4-35Toro GrandStand Service Manual
4
3. Install the hinge pin through one side of the upper
and lower shifter brackets, though the torsion spring,
then through the opposite end of the shifter brackets
(Fig. 0762).
Fig. 0762 IMG-1125a
4. Secure the hinge pin with a hairpin cotter and wash-
er on both ends (Fig. 0763).
Fig. 0763 IMG-1123a
5. Hook the “Z” bend of the speed control cable to the
shifter bracket assembly (Fig. 0764).
Fig. 0764 IMG-1071a
6. Loosely install the screw and cable clamp to the
shifter assembly (Fig. 0765).
Note: This clamp will be tightened later in this
process.
Fig. 0765 IMG-1070a