Toro GrandStand Series - Page 227

CONTROLS
4-40 Toro GrandStand Service Manual
4
Fig. 0781 DSC-0522a
Fig. 0783 DSC-0508a
8. The switch stop arm must be aligned with the cable
end of the control forks. Using a cable tie, secure
the neutral assembly to align the components (Fig.
0783).
Fig. 0782 DSC-0488a
7. Tighten the clamp securing the speed control cable
jacket to the shifter bracket (Fig. 0782).
A. LH control fork C. Cable tie
B. Switch stop arm D. RH control fork
6. Push the speed control linkage forward (Fig. 0781).
The Allen wrench establishes the intended air gap
between the rollers and end of the control linkage
slots.
A B
D
C