Toro GrandStand Series - Speed Control Adjustment

CONTROLS
4-39Toro GrandStand Service Manual
4
Speed Control Adjustment
5. Insert a 7/32” (approx. 5.6mm) Allen wrench into the
slots of the control fork and control arm in front of the
LH speed control linkage rollers (Fig. 0780).
1. Set the HOC lever to 2” (5cm), and then move the
speed control lever to the “FAST” position.
2. Loosen the cable clamp securing the speed control
cable jacket to the shifter bracket (Fig. 0777).
4. Remove the hairpin cotter and washer from the LH
speed control linkage (Fig. 0779).
Fig. 0777 DSC-0488a
3. Loosen the screws that go through the center of the
LH and RH shoulder hubs (Fig. 0778).
Fig. 0778 DSC-0514a
Fig. 0779 DSC-0513a
Fig. 0780 DSC-0504a