CONTROLS
4-42 Toro GrandStand Service Manual
4
Control Cable Replacement
This procedure was written using the left hand control
cable. This procedure is the same for either side.
Control Cable Removal
1. Remove the bolt, nut & spacer securing the lower
end of the control cable to the control fork assembly
(Fig. 0788).
Fig. 0788 IMG-1033a
2. Remove the spring clip securing the motion control
cable to the linkage mount (Fig. 0789).
Fig. 0789 IMG-1009a
3. Remove the motion control cable from the linkage
mount (Fig. 0790).
Fig. 0790 IMG-1035a
To Next Page
Loading...
