Toro GrandStand Series - Page 230

CONTROLS
4-43Toro GrandStand Service Manual
4
5. Remove the two thread forming screws, cable clamp
and spacer plate securing the control cable to the
cable bar (Fig. 0792).
4. Remove the bolt, nut and spacer securing the upper
end of the control cable to the motion control handle
assembly (Fig. 0791).
Fig. 0791 IMG-1093a
Fig. 0792 IMG-1098a
Control Cable Installation
1. Position the control cable with the cable’s locating
groove in line with the bolt holes in the cable bar
(Fig. 0793).
Note: Ensure the dust cover boot is covering the
joint between the cable sleeve and jacket.
Fig. 0793 IMG-1105a
2. Position the spacer plate between the cable and the
cable bar (Fig. 0794).
Fig. 0794 IMG-1107a