Toro GrandStand Series - Page 231

CONTROLS
4-44 Toro GrandStand Service Manual
4
3. Position the cable clamp on the control cable (Fig.
0795).
Note: Ensure the dimple in the cable clamp is
nested in the locating slot of the control
cable.
Fig. 0795 IMG-1113a
4. Secure the cable, cable clamp, and spacer to the
cable bar using two thread forming screws (Fig.
0796).
Fig. 0796 IMG-1098a
6. Loop the control cable up and behind the cable bar,
then back down towards the linkage mount (Fig.
0798).
5. Secure the upper end of the control cable to the
motion control handle assembly using a bolt, spacer
and nut (Fig. 0797).
Fig. 0797 IMG-1093a
Fig. 0798 IMG-1114a