Toro GrandStand Series - Page 244

ENGINE
5-3Toro GrandStand Service Manual
5
10. Remove the bolt and washer securing the ground
wires to the engine block (Fig. 0843).
12. Unplug the clutch wires from the wiring harness (Fig.
0845).
Fig. 0843 IMG-0467a
11. Remove nut and lock washer securing the starter
wire to the solenoid (Fig. 0844).
Fig. 0844 IMG-0470a
Fig. 0845 IMG-0474a
13. Push the grommet and the electrical plug connector
down through the engine base (Fig. 0846).
Fig. 0846 IMG-0493a