ENGINE
5-6 Toro GrandStand Service Manual
5
23. With a spring tool, remove the extension spring from
the spring anchor bracket (Fig. 0855).
Note: On 2009 machines the extension spring
hooks to the back of the engine base.
25. Remove the 3 carriage bolts and 3 nuts securing the
skid plate to the mower deck and remove the skid
plate (Fig. 0857).
Fig. 0855 IMG-0496a
24. Remove the hydraulic drive belt from around the
engine and hydraulic pump pulleys (Fig. 0856).
Fig. 0856 IMG-0497a
Fig. 0857 IMG-0503a
26. Remove one spark plug and feed a minimum of 2
feet (61cm) of 3/8” (.95cm) rope into the cylinder to
prevent engine rotation (Fig. 0858).
Note: Rotate crankshaft as needed to permit feeding
the rope into the cylinder.
Fig. 0858 IMG-9634a
To Next Page
Loading...
