Toro GrandStand Series - Page 26

CHASSIS
3-5Toro GrandStand Service Manual
3
5. Position the torsion spring over the spacer and
bolt. The straight end of the spring is secured by
the chassis, the curved end hooks under the brake
assembly (Fig. 0015).
Fig. 0015 IMG-1336a
6. Secure the RH assembly using the washer and nut
(Fig. 0016).
Fig. 0016 IMG-1324a
7. Position the carriage bolt through the RH side of the
control tower (Fig. 0017).
Fig. 0017 IMG-1338a
8. Position the switch plate onto the carriage bolt (Fig.
0018).
Note: The switch plate has a square hole that
must be nested onto the square shank of the
carriage bolt.
Fig. 0018 IMG-1344a