Toro GrandStand Series - Hydraulic Drive System; Pump Drive Belt Replacement

HYDRAULIC DRIVE SYSTEM
6-1Toro GrandStand Service Manual
6
Pump Drive Belt Replacement
Pump Drive Belt Removal
1. Remove the RH belt cover (Fig. 0904).
3. Remove the mower deck belt from around the clutch
pulley (Fig. 0906).
Fig. 0904 IMG-0796a
2. Using a spring tool, remove the mower deck idler
spring from the spring anchor (Fig. 0905).
Fig. 0905 IMG-0797a
Fig. 0906 IMG-0799a
4. Using a spring tool, remove the pump drive belt idler
spring from the spring anchor (Fig. 0907).
Note: On 2009 machines, the idler spring is an
chored to the back of the engine base.
Fig. 0907 IMG-0801a