HYDRAULIC DRIVE SYSTEM
6-2 Toro GrandStand Service Manual
6
Pump Drive Belt Installation
5. 2010 Only: The spring anchor is held in place by
spring tension. Once the spring is removed, the
anchor can be removed (Fig. 0908).
6. Remove the pump drive belt from around the engine
and pump pulleys.
A. Hydraulic pumps D. Clutch retainer
B. Idler pulley E. Pump drive belt
C. Clutch pulley F. Engine pulley
1. Position the pump drive belt around the engine, idler
and pump pulleys (Fig. 0909).
Fig. 0908 IMG-0803b
Fig. 0909 g. 66 G012686
A
B
C
F
D
E
To Next Page
Loading...
