Toro GrandStand Series - Page 262

HYDRAULIC DRIVE SYSTEM
6-3Toro GrandStand Service Manual
6
2. 2010 Only: Position the spring anchor into the
engine base (Fig. 0910).
Fig. 0910 IMG-0803b
4. Place the mower deck belt around the clutch pulley
(Fig. 0912).
3. Using a spring tool, secure the pump drive belt idler
spring to the anchor (Fig. 0911).
Note: On 2009 machines, the idler spring is an
chored to the back of the engine base.
Fig. 0911 IMG-0801a
Fig. 0912 IMG-0799a
5. Using a spring removal tool, secure the mower deck
idler spring to the spring anchor (Fig. 0913).
Fig. 0913 IMG-0797a