HYDRAULIC DRIVE SYSTEM
6-4 Toro GrandStand Service Manual
6
Pump Drive Belt Idler Replacement
Pump Drive Belt Idler Removal
6. Install the RH belt cover (Fig. 0914).
1. Using a spring tool, remove the pump drive belt idler
spring from the spring anchor (Fig. 0915).
Note: On 2009 machines, the idler spring is an
chored to the back of the engine base.
Fig. 0914 IMG-0796a
Fig. 0915 IMG-0801a
2. 2010 Only: The spring anchor is held in place by
spring tension. Once the spring is removed, the
anchor can be removed (Fig. 0916).
Fig. 0916 IMG-0803b
To Next Page
Loading...
