Toro GrandStand Series - Page 265

HYDRAULIC DRIVE SYSTEM
6-6 Toro GrandStand Service Manual
6
Pump Drive Belt Idler Installation
7. Remove the bolt, washers and nut securing the idler
pulley to the idler plate (Fig. 0921).
A. Bolt D. Idler plate
B. Washer (2) E. Nut
C. Idler pulley
A. Bolt D. Idler plate
B. Washer (2) E. Nut
C. Idler pulley
1. Secure the idler pulley to the idler plate using bolt,
washers and nut (Fig. 0922).
Note: The pulley hub needs to face the idler plate.
Fig. 0921 IMG-0810a
Fig. 0922 IMG-0810a
2. Insert the pivot bolt through the engine base (Fig.
0923).
Fig. 0923 IMG-0814a
A
B
C
D
E
B
A
B
C
D
E
B