Toro GrandStand Series - Page 267

HYDRAULIC DRIVE SYSTEM
6-8 Toro GrandStand Service Manual
6
8. 2010 Only: Position the spring anchor into the
engine base (Fig. 0929).
Fig. 0929 IMG-0803b
9. Using a spring tool, secure the pump drive belt idler
spring to the anchor (Fig. 0930).
Note: On 2009 machines, the idler spring is an
chored to the back of the engine plate.
Fig. 0930 IMG-0801a
7. Position the pump drive belt around the engine, idler
and pump pulleys (Fig. 0928).
A. Hydraulic pumps D. Clutch retainer
B. Idler pulley E. Pump drive belt
C. Clutch pulley F. Engine pulley
Fig. 0928 g. 66 G012686
A
B
C
F
D
E