HYDRAULIC DRIVE SYSTEM
6-22 Toro GrandStand Service Manual
6
3. Install 2 carriage bolts, nuts and washers securing
the pump to the frame (Fig. 0981).
Fig. 0981 IMG-9386a
4. Install the hoses/ttings to the ttings located on the
pump. Ensure the markings on the hoses match the
markings on the ttings/pump:
a. Install the high pressure hoses (Fig. 0982)
Fig. 0982 IMG-9383a
Left Hydraulic Pump Installation
1. Position the Pump Control Arm to the pump linkage
and install 2 bolts and nuts to secure (Fig. 0979).
Fig. 0979 IMG-9391a
2. Position the left hand pump into the frame. Align
the mounting ange on the pump with the mounting
holes in the frame (Fig. 0980).
Fig. 0980 IMG-9395a
To Next Page
Loading...
