Toro GrandStand Series - Page 289

HYDRAULIC DRIVE SYSTEM
6-30 Toro GrandStand Service Manual
6
28. 2009 only: Install a lock nut onto the lower end of
the lift bar securing it to the height-of-cut pin (Fig.
1010).
Fig. 1010 IMG-9345a
30. Lower the machine.
31. Remove the straps securing the mower deck (Fig.
1012). Lower the deck to the 1” (2.54cm) height-of-
cut position (Fig. 1012 and Fig. 1013).
Fig. 1012 IMG-9339a
Fig. 1013 IMG-9306a
29. 2010 only: Secure the lift bar to the HOC pin using
the lift dampener and nut (Fig. 1011).
Fig. 1011 IMG-0901a