Toro GrandStand Series - Page 288

HYDRAULIC DRIVE SYSTEM
6-29Toro GrandStand Service Manual
6
24. Slide the 2 traction control cables into the drive
linkage mount slots (Fig. 1006).
Fig. 1006 IMG-9351a
25. Install the spring clip into the drive linkage mount
(Fig. 1007).
A. 1.5” (3.8cm) for 60” decks
2” (5cm) for 48” & 52” decks
Fig. 1007 IMG-9350a
26. 2010 only: Secure the upper end of the lift assist
springs to the control tower with the adjustment
screw and washer (Fig. 1008).
Fig. 1008 IMG-0902a
27. 2010 only: Adjust the gap between the upper spring
bracket and the top of the spring nut insert (Fig.
1009).
Fig. 1009 IMG-0902a
A