Toro GrandStand Series - Page 315

HYDRAULIC DRIVE SYSTEM
6-56 Toro GrandStand Service Manual
6
27. 2010 only: Secure the upper end of the lift assist
springs to the control tower with the adjustment
screw and washer (Fig. 1108).
Fig. 1108 IMG-0902a
A. 1.5” (3.8cm) for 60” decks
2” (5cm) for 48” & 52” decks
28. 2010 only: Adjust the gap between the upper spring
bracket and the top of the spring nut insert (Fig.
1109).
Fig. 1109 IMG-0902a
A
26. 2009 only: Install a lock nut onto the lower end of
the lift bar securing it to the height-of-cut pin (Fig.
1107).
Fig. 1107 IMG-9345a