HYDRAULIC DRIVE SYSTEM
6-61Toro GrandStand Service Manual
6
49. Using a spring tool (Toro Part No. 92-5771), install
the pump idler extension spring (Fig. 1126).
Note: 2010 machines have the end of the extension
spring connected to an anchor, not the back
side of the engine base.
Fig. 1126 IMG-9545a
52. Rell the hydraulic oil as needed. Remove air from
the hydraulic system. Follow the “Bleeding the
Hydraulic System” procedure on page 6-95.
53. Test operate the machine. Adjust tracking and
neutral as needed.
50. Lower the machine.
51. Turn the fuel shut-off valve to the ON position (Fig.
1127).
Fig. 1127 IMG-9284a
To Next Page
Loading...
