HYDRAULIC DRIVE SYSTEM
6-64 Toro GrandStand Service Manual
6
11. Remove the wheel motor axle nut (Fig. 1135).
Fig. 1135 IMG-9921a
12. Install a hub puller (Toro p/n: TOR6006) onto the
wheel studs.
Note: The lug nuts should be installed backwards
so the at side is against the puller (Fig.
1136).
Fig. 1136 IMG-9925a
13. Advance the forcing screw through the hub until it
rmly contacts the wheel motor shaft (Fig. 1137).
Fig. 1137 IMG-9929a
To Next Page
Loading...
