Toro GrandStand Series - Page 324

HYDRAULIC DRIVE SYSTEM
6-65Toro GrandStand Service Manual
6
14. Tighten the lug nuts evenly (approximately 1/4 to 1/2
turn at a time) until the hub pops off the wheel motor
shaft (Fig. 1138 and Fig. 1139).
Fig. 1138 IMG-9932a
Fig. 1139 IMG-9935a
15. Remove the hub puller from the hub.
16. Remove the woodruff key from the keyway (Fig.
1140).
Fig. 1140 IMG-9938a
17. Thoroughly clean the area around the hydraulic
ttings to prevent debris from entering the system.
18. Mark the hose and wheel motor ttings to identify the
upper and lower hoses (Fig. 1141).
Fig. 1141 IMG-9876a