HYDRAULIC DRIVE SYSTEM
6-68 Toro GrandStand Service Manual
6
28. 2009 only: While supporting the motor mount
assembly, remove the two nuts (leave the bolts)
attaching the motor mount assembly to the frame
assembly (Fig. 1150).
Fig. 1150 IMG-9956a
Note: 2010 models use bolts, spacers and nuts to
secure the motor mount to the frame (Fig.
1151).
Fig. 1151 DSCN-1020a
29. Lower the motor mount assembly just enough to
allow the bolts to clear the holes in the frame as-
sembly and then remove the motor mount assembly
out to the side of the machine (Fig. 1152).
Fig. 1152 IMG-9961a
30. Remove the 4 bolts securing the wheel motor to the
motor mount assembly (Fig. 1153).
Fig. 1153 IMG-9965a
To Next Page
Loading...
