Toro GrandStand Series - Page 326

HYDRAULIC DRIVE SYSTEM
6-67Toro GrandStand Service Manual
6
23. Remove the upper tting from the wheel motor. Cap
the wheel motor port so that debris does not enter
the system. (Fig. 1146).
Fig. 1146 IMG-9897a
24. Repeat steps 22 and 23 to remove the lower wheel
motor tting.
25. Remove the 2 lower carriage bolts and nuts securing
the center motor mount to the LH and RH motor
mount assemblies (Fig. 1147).
Fig. 1147 IMG-9948a
26. Remove the upper carriage bolt and nut from the
center motor mount closest to the wheel motor being
removed (Fig. 1148).
Fig. 1148 IMG-9949a
27. Loosen the remaining nut until it is ush with the end
of the carriage bolt (Fig. 1149).
Fig. 1149 IMG-9953a