Toro GrandStand Series - Page 331

HYDRAULIC DRIVE SYSTEM
6-72 Toro GrandStand Service Manual
6
9. Install the two ttings into the wheel motor ports (Fig.
1164).
Fig. 1164 IMG-9999a
10. Position the ttings as shown and tighten the jam
nuts (Fig. 1165).
Fig. 1165 IMG-9892a
11. Install both hydraulic hoses to the wheel motor.
Make sure the hoses are routed to the correct tting
(marked earlier) (Fig. 1166).
Fig. 1166 IMG-9877a
12. Install the woodruff key into the wheel motor shaft
keyway (Fig. 1167).
Fig. 1167 IMG-9938a