Toro GrandStand Series - Page 371

MOWER DECK
7-16 Toro GrandStand Service Manual
7
7. Remove the spindle housing assembly from the
spindle shaft (Fig. 1297).
Fig. 1297 IMG-9795a
8. Remove the thrust washer from the spindle shaft.
(It may stick to the bottom of the spindle housing.)
(Fig. 1298)
Fig. 1298 IMG-9797a
9. Remove the bearing shield from the spindle shaft
(Fig. 1299).
Fig. 1299 IMG-9796a
10. Drive out one of the bearings from the spindle
housing (Fig. 1300).
Fig. 1300 IMG-9798a